
BionX Throttle Module for G2 controller, Short cables
BionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...
View full detailsBionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...
View full detailsG2 Controller, Black, Comes pre-programmed with firmware rev 64.2Code 3773 is functional. Please carefully look at the rear contacts picture. As so...
View full detailsBionX Docking Station for G2 controller. Receptacle only no G2 controller included. no clips, no rubbers, no screws, as pictured. A few length op...
View full detailsRC3 Throttle (3rd Generation controller). Short cable version (01-5590) for downtube batteries.RC3 only (no brake switch 2.5mm cable included) Comp...
View full detailsBionX Trek RIDE+ Pro Controller usually used on Trek bicycles. It is using the same docking as the G2 controller 01-3205 and can be used on non Tre...
View full detailsDS3 Display Kit Assembly (With docking and center arm) Includes;01-5564 - DS301-5780 - DS3 Dock, Center mount, and shims. Must be used with RC3 an...
View full detailsThis is the first BionX G1 classic controller. The handle bar clip is not included. For CAN bus system (not for older I2C) There is no throttle le...
View full detailsRC3 Brake Switch, 2.5mm Jack. Normally closed. To be used with RC3 controllers. Can be purchased without the adhesive foam holder 01-5940 Or with t...
View full detailsService Kit - Docking Station for all G2 controllers.Includes; 1x Console Receptacle. Different wire lengths available;. 01-4451, 10.7CM cable d...
View full detailsRC3 Throttle (3rd Generation controller).Long cable length for rear rack batteries.Only the RC3 throttle included. Does not comes with 3.5mm brake ...
View full detailsBionX Smart Bikes G2 controller docking station, 01-4261 Specifically used on Smart E-bike based using BionX technology Will accept BionX G2 cont...
View full detailsReed Switch Adhesive Mount. For all BionX brake sensors. Two version are available; 01-1287A; For G2 brake switch. Standard hole size 01-1287B; For...
View full detailsBionX Docking station assembly for DS3 display. Comes with; DS3 Docking with 3.5mm jack. Left and right plastic arms 3 set of shims with different...
View full detailsG2 consoles Central Mount docking station. With 6X rubber shims (No G2 controller included)
DS3 color Display (3rd Generation color Display). Features include: Transflective color display Quarter-turn mounting mechanism Protective rubber ...
View full detailsG2 controllers Reed Switch Assembly. - Normally Closed, 17.5cm. - No magnet included. No foam adhesive included; 01-1283 With form adhesive include...
View full detailsBionX Docking Station for RIDE+ EASY1 and EASY2 smaller controllers usually found on Trek bicycles. Main communication cable length is 80cm Brake...
View full detailsBionX G2 throttle for Trek RIDE+ Pro bikes. - This throttle is usually used with Trek RIDE+ Pro controller.- Comes with a 2.5mm audio jack connecto...
View full detailsStay informed about us:
info@BX-Legacy.com
Copyright © 2021 BX Legacy.