BionX classic G1 Controller, without throttle lever, 01-2331

Sold out

This is the first BionX G1 classic controller.

  • For CAN bus system (not for older I2C)
  • There is no throttle lever on this one, only assist/regen levels.
  • The throttle module can not be used with this controller (01-4474).
  • Is also not compatible with G2 dockings (01-3328) and needs a specific handle bar clip (not included)
  • Comes pre-programmed with firmware rev 64
  • Default pre-programmed wheel diameter is 700c, no speed limit. Send us your specific wheel diameter when ordering if different than 700C.
  • Communication cable length is about 11cm, brake sensor 8cm
  • Part number 01-2331

The handle bar clip is not included.
If you need the clip, see part number 01-1120