G2 Controller, Black, Comes pre-programmed with firmware rev 64. No docking included!
BionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...View full details
BionX Docking Station for G2 controller. Receptacle only no G2 controller included. no clips, no rubbers, no screws, as pictured. A few length op...View full details
RC3 Throttle (3rd Generation controller). Short cable version (01-5590) for downtube batteries.RC3 only (no brake switch 2.5mm cable included) Comp...View full details
DS3 Display Kit Assembly (With docking and center arm) Includes;01-5564 - DS301-5780 - DS3 Dock, Center mount, and shims. Must be used with RC3 an...View full details
Service Kit - Docking Station for all G2 controllers.Includes; 1x Console Receptacle. Different wire lengths available;. 01-4451, 10.7CM cable d...View full details
Reed Switch Adhesive Mount. Fo all BionX brake sensors.
RC3 Brake Switch, 2.5mm Jack. Normally closed. To be used with RC3 controllers. To purchase adhesive, see product 01-1287 (Normaly open version av...View full details
BionX Trek RIDE+ Pro Controller usually used on Trek bicycles. It is using the same docking as the G2 controller 01-3205 and can be used on non Tre...View full details
RC3 Throttle (3rd Generation controller).Long cable length for rear rack batteries.Only the RC3 throttle included. Does not comes with 3.5mm brake ...View full details
G2 consoles Central Mount docking station. With 6X rubber shims (No G2 controller included)
This is the first BionX G1 classic controller. For CAN bus system (not for older I2C) There is no throttle lever on this one, only assist/regen le...View full details
G2 controllers Reed Switch Assembly. Normally Closes, 175mm. Not magnet included. No foam adhesive included.
BionX Docking station assembly for DS3 display. Comes with; DS3 Docking with 3.5mm jack. Left and right plastic arms 3 set of shims with different...View full details
BionX Smart Bikes G2 controller docking station, 01-4261 Specifically used on Smart E-bike based using BionX technology Will accept BionX G2 cont...View full details
DS3 color Display (3rd Generation color Display). Features include: Transflective color display Quarter-turn mounting mechanism Protective rubber ...View full details
BionX Docking Station for RIDE+ EASY1 and EASY2 smaller controllers usually found on Trek bicycles. Main communication cable length is 80cm Brake...View full details
BionX G2 throttle for Trek RIDE+ Pro bikes. - This throttle is usually used with Trek RIDE+ Pro controller.- Comes with a 2.5mm audio jack connecto...View full details