Bionx Controls

Bionx DS3, RC3, G2 consoles, etc
BionX Throttle Module for G2 controller, Short cables
$99.99
$49.99

BionX Throttle Module for G2 controller, Short cables

BionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...

View full details
$99.99
$49.99
RC3 Throttle for DT batteries
$199.99
$124.99

RC3 Throttle for DT batteries

RC3 Throttle (3rd Generation controller). Short cable version (01-5590) for downtube batteries.RC3 only (no brake switch 2.5mm cable included) Comp...

View full details
$199.99
$124.99
BionX G2 Controller Docking only, (different cable length options)
$79.99
$49.99

BionX G2 Controller Docking only, (different cable length options)

BionX Docking Station for G2 controller. Receptacle only no G2 controller included. no clips, no rubbers, no screws, as pictured. A few length op...

View full details
$79.99
$49.99
G2 Controller Alone (No Docking)
Sold out
$299.99
from $224.99

G2 Controller Alone (No Docking)

G2 Controller, Black, Comes pre-programmed with firmware rev 64.2Code 3773 is functional. Please carefully look at the rear contacts picture. As so...

View full details
$299.99
from $224.99
Sold out
RC3 Throttle for RR batteries.
$199.99
$124.99

RC3 Throttle for RR batteries.

RC3 Throttle (3rd Generation controller).Long cable length for rear rack batteries.Only the RC3 throttle included. Does not comes with 3.5mm brake ...

View full details
$199.99
$124.99
DS3 Display Kit Assembly
$249.99
$149.99

DS3 Display Kit Assembly

DS3 Display Kit Assembly (With docking and center arm) Includes;01-5564 - DS301-5780 - DS3 Dock, Center mount,  and shims. Must be used with RC3 an...

View full details
$249.99
$149.99
BionX Trek RIDE+ Pro controller (Only the controller, No Docking included), 01-3855
Sold out
$249.99
$174.99

BionX Trek RIDE+ Pro controller (Only the controller, No Docking included), 01-3855

BionX Trek RIDE+ Pro Controller usually used on Trek bicycles. It is using the same docking as the G2 controller 01-3205 and can be used on non Tre...

View full details
$249.99
$174.99
Sold out
BionX classic G1 Controller, without throttle lever, 01-2331
Sold out
from $89.99

BionX classic G1 Controller, without throttle lever, 01-2331

This is the first BionX G1 classic controller. For CAN bus system (not for older I2C) There is no throttle lever on this one, only assist/regen le...

View full details
from $89.99
Sold out
RC3 brake switch. 2.5mm connector, NC
from $19.99

RC3 brake switch. 2.5mm connector, NC

RC3 Brake Switch, 2.5mm Jack. Normally closed. To be used with RC3 controllers. Can be purchased without the adhesive foam holder 01-5940 Or with t...

View full details
from $19.99
BionX G2 Controller Docking Station Service kits
$99.99
$69.99

BionX G2 Controller Docking Station Service kits

Service Kit - Docking Station for all G2 controllers.Includes; 1x Console Receptacle. Different wire lengths available;.  01-4451, 10.7CM cable d...

View full details
$99.99
$69.99
BionX - 3rd Gen controls upgrade kit: RC3, DS3, DOCKING. 01-6008 to 01-6011
from $249.99

BionX - 3rd Gen controls upgrade kit: RC3, DS3, DOCKING. 01-6008 to 01-6011

** RC3 and DS3 are only compatible with 48 volts batteries. (not 36v or less)  This is an upgrade kit to replace older G1 or G2 controllers. The 01...

View full details
from $249.99
BionX Smart E-Bike G2 controller docking station, 01-4261
Sold out
$149.99
$74.99

BionX Smart E-Bike G2 controller docking station, 01-4261

BionX Smart Bikes G2 controller docking station, 01-4261 Specifically used on Smart E-bike based using BionX technology Will accept BionX G2 cont...

View full details
$149.99
$74.99
Sold out
G2 controller reed switch, Normaly closed
from $19.99

G2 controller reed switch, Normaly closed

G2 controllers Reed Switch Assembly. - Normally Closed, 17.5cm. - No magnet included. No foam adhesive included; 01-1283 With form adhesive include...

View full details
from $19.99
BionX DS3 Display Docking station assembly (No DS3 included) 01-5780
$99.99
$29.99

BionX DS3 Display Docking station assembly (No DS3 included) 01-5780

BionX Docking station assembly for DS3 display. Comes with; DS3 Docking with 3.5mm jack. Left and right plastic arms 3 set of shims with different...

View full details
$99.99
$29.99
BionX DS3 Color Display (Only the display, No Docking included), 01-5564
$229.99
$124.99

BionX DS3 Color Display (Only the display, No Docking included), 01-5564

DS3 color Display (3rd Generation color Display). Features include: Transflective color display Quarter-turn mounting mechanism Protective rubber ...

View full details
$229.99
$124.99
Reed Switch Adhesive Mount  - 01-1287
$9.99
$4.99

Reed Switch Adhesive Mount - 01-1287

Reed Switch Adhesive Mount. For all BionX brake sensors. Two version are available; 01-1287A; For G2 brake switch. Standard hole size 01-1287B; For...

View full details
$9.99
$4.99
G2 central mount kit assembly with rubbers. Fits all G2
$69.99
$34.99

G2 central mount kit assembly with rubbers. Fits all G2

G2 consoles Central Mount docking station. With 6X rubber shims (No G2 controller included)

$69.99
$34.99
BionX RIDE+ EASY I & II Controllers Docking, kit, clip
from $9.99

BionX RIDE+ EASY I & II Controllers Docking, kit, clip

BionX Docking Station for RIDE+ EASY1 and EASY2 smaller controllers usually found on Trek bicycles. No EASY I or II controller included! (as pictur...

View full details
from $9.99
BionX G2 throttle for Trek RIDE+ Pro bikes. (Only the throttle, no controller included) 01-4083
$99.99
$49.99

BionX G2 throttle for Trek RIDE+ Pro bikes. (Only the throttle, no controller included) 01-4083

BionX G2 throttle for Trek RIDE+ Pro bikes. - This throttle is usually used with Trek RIDE+ Pro controller.- Comes with a 2.5mm audio jack connecto...

View full details
$99.99
$49.99
USED BionX classic G1 Controller, with throttle lever, 01-2332
Sold out
from $99.99

USED BionX classic G1 Controller, with throttle lever, 01-2332

This is for a USED controller.  100% tested and functional. This is the first BionX G1 classic controller. For CAN bus system throttle lever insta...

View full details
from $99.99
Sold out
BionX G1 controller Handlebar Clip assembly. (clip only no controller) 01-1120
Sold out
$9.99

BionX G1 controller Handlebar Clip assembly. (clip only no controller) 01-1120

G1 'classic' Controller handle bar clip o'ring. Attaches to your bike’s handlebars and acts as mounting platform for the Bionx G1 (01-2331) conso...

View full details
$9.99
Sold out
BionX FRONT MOTOR Docking Docking kit
$79.99
$9.00

BionX FRONT MOTOR Docking Docking kit

BionX Docking Station for FRONT MOTOR bikes.Usually used on European TREK bikes.  ONLY COMPATIBLE WITH FRONT MOTOR SYSTEMS. COMPATIBLE WITH G2 ...

View full details
$79.99
$9.00